Factory Grips

Q: On a 2008 SG is there a trick to changing out the factory grips? I have put new grips on used the manual step by step but it keeps stalling and losing power, if I smack the end of the grip it gives me my throttle back. This cannot be that hard to do what am I missing?

A: You, most likely, pinched the right side switch housing wiring harness.

Reply: Thanks you were right I pinched it

Related Video: Chrome Switch Cap Install

Share tips, start a discussion or ask other students a question. If you have a question for the instructor, please click here.

Make a comment:
characters remaining

7 Responses to “Factory Grips”

  1. Anthony Johnson

    Hi I got a 2006 Ultra Classic Electra Glide I just upgraded the motor from a 88 to a 103 having the hardest time trying to line up the motor can you give me some tips on that how to get the motor lined up.

  2. adolfo

    do you have the PN for this heaters??

  3. Steve

    Can a drive belt on a 1994 fxdwg be replaced without removing the rear wheel and swing arm by simply removing the shock absorber lower bolt and pushing the rear wheel forward to obtain the slack needed to remove it from the rear and front sprockets?

  4. Jom hunt

    I have an 03 883 sportser that will only idle with the enricher out a1/4” fully warmed up. The carb was cleaned and serviced by a Harley mechanic right before I purchased it. It just now has 1055 miles on it. It had 710 when purchased. I have run sea foam and several tanks of fuel through it, and it still has to ne out that much to idle. Will occasionally sneeze back through the carb when taking off from a stop. Was wondering if it os a possible vacuum leak. Thanks for any help you can give me in advance.

  5. Jimbo

    <strong> Ticket 22308 to change the factory heated grips on my bike. Do I have to pull the wires from the handle bars?

  6. Francisco A.

    <strong> Ticket 17939 How do I change the factory grid on my bike 2012 Softail Deluxe.

  7. SAMUEL

    How do I change out hand grips on my bike?